Starting up a tanning salon 6

Cont: How to Start Up your Tanning Salon 6

Buck/Boost Transformers: The voltages of the tanning beds vary a great deal. Most salons have three phase 208V services. The 208V is a nominal rating, it can actually vary from 205V to 215V. However, most commercial tanning beds only operate correctly if the voltage is at least 220V, and most beds are rated 220V to 230V.

The buck/boost transformer is essentially a voltage stepping device. Depending on the transformer itself, it will actually adjust the incoming voltage, either up or down. it is a common misconception that they adjust and go up and down as the voltage changes. They are actually a fixed ratio machine, and if it is designed to raise your voltage 10%, that's what it will do. They are not a continuously voltage correcting device.

The actual voltage at your particular location will need to be measured so that you know what kind of a buck/boost transformer you need. You will also see a drop in the voltage when several tanning beds are operating at once. It will probably be best to use a transformer that will raise your current voltage to the 235V range, such that when it is fully loaded, it will give you a full 230V.

There are some warning signs which indicate that you need a transformer such as the lamps will not light, or they light up slowly or are darker than normal. It is very important to run your bed at the correct voltage so that it will not become damaged and also so that you will not void the warranty.

Go to page 1 2 3 4 5 6